Printer Setup in Rosa 2012.1 RC

[linukiss]

I'm trying to configure an HP network printer, but the printer configuration panel does not open, of the following message


I did not install any printer setup package, use only what is in the Rosa

[d_uragan]

Mm, smth is wrong with the image attachment - I don't see anything...

[akdengi]

run system-config-printer...

[d_uragan]

I'm trying to configure an HP network printer, but the printer configuration panel does not open, of the following message

I did not install any printer setup package, use only what is in the Rosa

Hm, the printer configuration panel should launch system-config-printer, it is strange that it claims about 'printer' executable.

Can you check the version of 'kcm-printer' package (show the output of "rpm -qi kcm-printer")? The freshest one has version 1.0 and release 7.

You can also check that system-config-printer tool is present and can be launched.

[linukiss]

after the last update everything is operating normally, sorry my bad english, I'm brazilian